Connect the A/, B/, and Z/ inputs of the optical isolator to circuit common of the encoder supply. Connect each encoder signal to its like optical isolatorĮncoder signal from 5 VDC to 24 VDC (must specify the voltage when ordering)Ĭonnect encoder output A to optical isolator module input channel A, B to B and Z to Z. This is the preferred type of encoder output as it has the best noise immunity. 02125-0Įncoder signals from 5 VDC to 24 VDC (must specify the voltage when ordering) Supply lines protected against over voltage to 60 volts and reverse voltage Single ended, open collector (Use Connection Instructions #3)ĥ VDC (TTL, RS422 compatible, line driver)Ģ8V/V Line Driver, 100mA source/sink, Vout = VinĢ8V/5 Line Driver, 100mA source/sink, Vout = 5V (Derate output current to 50mA with supply voltage > 12VDC) It has a 1 MHz throughput capability and can be used wherever a fast, optically isolated interface is required.
#OPTICAL ISOLATOR MODULE DRIVER#
This Optical Isolator can help clean up noisy signals by converting to a different line driver output.
Single ended open collector with pull-up resistors internal to encoder (Use Connection Instructions #3) Up to eight Optical Isolator Modules can be daisy-chained to provide multiple, simultaneous outputs to controllers or PLC’s. Single ended line driver (Use Connection Instructions #2) Data lines are designated A, B, Z, A/, B/, Z/ at theĭifferential line driver (Use Connection Instructions #1)
#OPTICAL ISOLATOR MODULE PLUS#
The module simply snaps directly to the DIN rail and is ready to use.ĭual Channel in quadrature plus index and complements. The signal pairs for each Digital Output is. A length of DIN rail is supplied with each module. The Opto-Isolation module converts a BaseBoard Digital Output to an optically isolated signal pair: RT and OUT. The package mounts to a DIN rail type EN 50 022 (35mm X 7.5mm). Package dimensions are 114.4 mm high by 99 mm wide by 22.5 mm thick. changeover switches - auxiliaries and accessories Isolator switches. Specifying an optical isolator module requires knowledge of three system parameters: the DC supply voltage available in the system the encoder output type (logic levels and driver type) and the input signal specifications of the receiving electronics. Add-on modules DX - for 1 module/pole DX MCBs Add-on modules DX - for 1.5. Any encoders used in conjunction with this module must be connected to their own power. The optical isolator module does not provide power to the encoder. The module draws approximately 75 mA and a green LED indicates the unit is powered. It should never be connected directly to AC power mains.
In order to achieve protection, SLAVE device must be powered by other power source than MASTER device (TapHome Core and Modules).The optical isolator can accommodate standard operating voltages from 5 to 28 VDC. The isolator must always be installed on the side of one of the protected devices (MASTER) - as close as possible to it. MASTER side is protected device, typically TapHome Core control unit
#OPTICAL ISOLATOR MODULE SERIAL#
High-speed data transmission to your equipments serial I/O bus. In this case, also power source must be galvanically isolated - the easiest way is to use separate power source. Provides 8 serial ports via terminal block with Optical Isolation. Product Details Isolator Barriers Our Bulletin 937T Isolator Barriers include galvanic optical or transformer isolation, these modules provide an interface within the intrinsic safety circuit that is electrically separated from the control system. This is the most common situation when when connecting TapHome modules in the garden house, or meteo station on the roof. Simultaneous monitoring of power, wavelength, and channel number for a tunable laser is demonstrated by use of a combination of an optical isolator, an etalon, a polarizer, and photodiodes.
0 kommentar(er)
